User Manual

Table Of Contents

CL Editor Owner’s Manual

ST IN window

In this window you can view and edit the mix parameters of ST IN channels 1–8. The parameters shown in the window can

be selected from the [View] menu or the menu that appears when you right-click (<control> key + click) in the window.

You can access this window in the following ways.

• From the [Windows] menu, choose [Overview] and then choose “ST IN”

• Use the bank select keys in the Main window to turn on the [ST IN] button

1 Input patch

Selects the input source that will be assigned to the ST IN channel. The input sources that

can be assigned are the same as for an INPUT CH (➥ p.17.)

2 HA (HA analog gain)

Drag the knob in the screen to adjust the analog gain of the internal head amp or of the

external head amp patched to the ST IN channel.

3 48V (Phantom power)

Switches on/off the phantom power (+48V) of the internal head amp or of the external head

amp patched to the ST IN channel.

4 Ø (Phase)

Inverts the phase polarity of the signal after AD conversion.

5 Digital Gain

Drag the knob in the screen to adjust the input gain to each ST IN channel.

6 HPF (High Pass Filter)

Switches the high pass filter on/off. You can drag the numeric value up or down to edit the

cutoff frequency.

7 LR-MONO SELECT

Enables you to select STEREO, L-MONO, R-MONO, or LR-MONO for ST IN channel

mode.

8 EQ (Equalizer)

Switches the EQ on/off (the L/R settings are linked.) This is the same as the equalizer for

INPUT CH (➥ p.18.)