User Manual
Table Of Contents
- Copyright
- About Audinate
- Introduction
- Installing Dante Controller
- Dante Basics
- Discovery and auto-configuration
- Device Channels
- Differentiating between input and output channels
- Device Names and Channel Labels
- Routing Audio
- Clock Synchronization
- Latency
- Device Lock
- Dante Control and Monitoring
- Starting Dante Controller
- Using Dante Controller
- Network View
- Status Bar
- Network View Tabs
- Channel Groups
- Clock Status Monitoring
- Clock Status Monitor
- Automatic Notification of Device Errors
- Device View
- Device View Tabs
- Multicast Transmit Flow Configuration
- Using Dante Controller with Dante Domain Manager
- Presets
- Troubleshooting
- Fanout
- Messages on Startup
- Computer Configuration Checklist
- Troubleshooting Dante IP Address Configuration
- Troubleshooting Switch Configuration and Cabling
- Index
Dante Controller User Guide
Copyright © 2018 Audinate Pty Ltd. All rights reserved.
-59-
Events
The Events tab provides information on significant changes and failures in the network.
Dante Controller continually monitors Dante devices and the network as a whole. It is able to watch for
problematic configurations, unexpected problems and communication failures between itself and Dante
network devices. Events are displayed and stored in an event log.
Events fall into one of three categories: Information, Warning and Error.
Filtering the Event List
Use the drop-down menu at the bottom left of the view to filter the events list.
n When set to Information, all events are shown.
n When set to Warning, only warning and error events are shown.
n When set to Error, only error events are shown.
Clearing the Event List
To clear the event list, click the Clear button. When new events are detected that match the current filter
setting, they are displayed in the event list.
If you have switched to another Network View tab, new events in the event list will also be indicated by a
red Event Log LED icon in the Status Bar. Clicking the LEDicon will take you straight to the Events tab
and will clear the Event Log LED.
Note: The Event Log LED icon will always remain green while the Events tab is open.