User Manual

Table Of Contents

■ Error Message List (R Series Update Program V2)

Error messages (that consist of an error number and a string in English) for the R Series Update

Program V2 may be displayed on the computer.

This section explains the error numbers, the English strings, and the appropriate action to take.

・ If the same error message appears each time you try to update, the device may need repairing, in which case you

should contact your Yamaha dealer.

Number Cause Possible Solution

[ERROR:001]～[ERROR:006]

、

[ERROR:101]～[ERROR:107]

An error occurred while communicating with

the device.

Make sure that the computer is

connected to the Ri/Ro correctly, then

restart the R Series Update Program

V2 and the Ri/Ro unit.

(

→ P. 7 )

[ERROR:009] The Ri/Ro is not engaged in Update mode. After turning the Ri/Ro power off, pull

the dip switches 4 and 8 down (ON)

and put all other switches (OFF) and

then turn the power on. (→ P. 7 )

[ERROR:108]、[ERROR:109]

Information on the Ri/Ro could not be

obtained.

The device may need repairing, in

which case you should contact your

Yamaha dealer.

[ERROR:111] The firmware data file was not found. Place the “RI8RO8_PROG.bin” file in

the folder that contains the

“updatev2.exe” file.(→ P. 7 )

Manual Development Department