User Manual

Basic process

Using the creation of a simple page as an example, this section

explains the process from startup to controlling a device. In this

example, we control the level and on/off for input channel 1 of a

CL5 (console ID=1).

In the case of an MRX, this procedure cannot be used to place a wid-

get; refer to “Adding parameters or meters for an MTX/MRX sys-

tem.”

Here’s how to start ProVisionaire Control, create a controller and

page, and register a device to control.

1. Start ProVisionaire Control.

To start, choose [Start] button[All Programs] or [All Apps][Yamaha

ProVisionaire Control][ProVisionaire Control V3.8].

2. If you want to create a new project, click [New Project]

button .

If you want to load an existing file, choose the [File]

menu command [Open Project File], and select the file

that you want to load.

In this example, we explain the procedure when you click [New Proj-

ect] button.

3. When the “Setup” dialog box appears, click [OK] or

[Cancel].

ProVisionaire Control transitions to design mode, and the “New Proj-

ect Wizard” dialog box opens.

NOTE

Select the network adapter and click [OK], you can verify the

devices by connecting the computer in which ProVisionaire Control

is installed to the network. In the “Devices” area, right-click the

applicable device and choose [Add] to register it.

Start up, and register devices