User Manual
Table Of Contents
- Contents
- PRECAUTIONS
- Introduction
- About Dante
- Controls and Functions
- Display Operations
- Operation Flow
- Menu structure
- Selecting menu items
- About the parameter display
- Selecting ports
- About port names
- METER menu
- GAIN menu
- +48V ON menu
- HPF ON menu
- HPF F menu
- GC (Gain Compensation) ON menu
- About the status indication
- SETUP menu
- Status bar
- INFORMATION menu
- Support for Dante Domain Manager (DDM) (V1.10 or later)
- Other functions
- About Connections
- Head Amp Control
- Troubleshooting
- Specifications
Display Operations
Owner’s Manual
14
METER menu
Level meters for all input ports are shown at the left, and level meters for all output ports are shown at the right.
The upper part of the display shows icons that indicate the +48V ON, HPF ON, and GC ON status of the selected port.
Rio3224-D2
Rio1608-D2
Viewing the meters
Head amp (HA) gain value settings
By turning the encoder with switch, you can adjust the HA gain value of the selected port. This can be adjusted in the
range of –6 dB to +66 dB, in 1 dB units.
When there is an input or output of –3 dBFS or greater
When there is an input or output greater than –18 dBFS and not exceeding –3 dBFS
When there is an input or output greater than –60 dBFS and not exceeding –18 dBFS
NOTE
PEAK HOLD is always on, but you can clear the PEAK held for each port by pressing
the encoder switch.