User Manual
14.9.7. "Pilot Tone" component editor
You can make settings to specify whether a pilot tone is output from digital output.
When the PILOT TONE [ON] button is turned on, the pilot tone is set to the YDIF or Dante output channel that has
been assigned to pilot tone output.
① PILOT TONE[ON] button
Sets the ON/OFF status of the pilot tone function. If OFF, the pilot tone will not be sent even if the ”YDIF” or
"DANTE” is set to ON.
② Freq.
Indicates the center frequency of the pilot tone. This is fixed at 20 kHz.
③ [LEVEL]knob
Specifies the level of the pilot tone.
④ YDIF button
The screen to set the pilot tone output to YDIF opens when this is clicked.
⑤ DANTE button(MTX5-D only)
The screen to set the pilot tone output to DANTE opens when this is clicked.
14. Audio Processors : MTX5-D/MTX3
ProVisionaire Design User Guide | 233