User Manual

26.4.3. DCP component: Settings dialog (knob)
Click the No. icon of the DCP component editor to open it.
Function
•
[No Assign]
Function is not assigned.
• [MTX Level / MTX Send Level]
•
[Parameter Range]
Use [Upper Limit] and [Lower Limit] to specify the range in which the level can be varied.
◦ [Mute Enable]
If [Mute Enable] is on, the Mute state (–∞ dB) will be enabled if the level is lowered below the value
specified by [Lower Limit].
•
[Nominal]
Here you can make settings for the Nominal function.
By specifying the nominal value, you can assign a specific LED position as the normal volume setting. For
example by specifying the center LED as the volume setting for normal use and setting the maximum
value to the maximum volume that is allowable for the system, you can prevent damage to the system
that might occur if the volume of the background music were raised during a noisy time.
26. DCP
ProVisionaire Design User Guide | 339