User Manual
Table Of Contents
- ■ Precautions (Please be sure to read this section first!)
- ■ Update procedure sequence
- ■ Checking the version number
- ■ Preparing for the update
- ■ Updating the RMio64-D firmware
- ■ Installing the Dante Firmware Update Manager
- ■ Computer TCP/IP setting
- ■ Updating the Dante firmware
- ■ About Failsafe Mode
- ■ Error Message List (RMio64-D Update Program)
12
If the RMio64-D is not indicated, click [Refresh]. If this field is empty, your
computer may not be properly connected to the RMio64-D. Check that the cable is
not loose or disconnected, that TCP/IP is properly configured, and that the RMio64-
D is turned on.
9.
Click [Start].
The update operation will begin.
“Updating” appears in the Status field during updating. “Done” is displayed once
update is completed.
Notice:
Update takes 2 to 4 minutes. During the update operation, do not turn off the
power to the unit or disconnect the cable. If update fails due to disconnection of the
power cable during the update, or due to other reasons, the device may become
inoperative.
If update is not completed after 5 minutes, or update failure indication appears,
click X at the upper right corner of Dante Firmware Update Manager to exit the
program without turning the RMio64-D power off, and restart the procedure from
the step 3. If update still fails, follow the instructions stated in “
About
Failsafe
Mode” to perform the recovery process.
10.
Restart the RMio64-D.
The firmware update is now complete.
Check that the firmware version has been updated.(→P.2
)