User Manual

R Remote Version 3 User’s Guide 22
Red (On)
UNLOCK
A valid clock is not being input from the card. If an external device is connected to the
corresponding slot, input/output cannot occur correctly between that device and the
RSio64-D.
Red
(Flashing)
WRONG
WORD
CLOCK
The frequency of the clock source selected with the [WORD CLOCK] select key is
outside of the operating frequency range for the card inserted in the slot. Either set
the frequency of the clock source within the operating range for the card, or turn
[SRC] ON. For an analog card, if you turn [SRC] ON, the frequency is set to the
48kHz built into the RSio64-D.
④ SLOT1～4 [SRC] indicators
Indicate the Sampling Rate Converter (SRC) status for slots 1 to 4.
Off
SRC is off.
Green
(On)
SRC is on, and the clock selected with the SRC WCLK DIP switches on the RSio64-D
is being input correctly.
Red (On)
SRC is on, but an appropriate clock is not being input. The clock selected with the
SRC WCLK DIP switches on the RSio64-D is either not being input or is not within
the operating range. Either turn SRC off, or change the DIP switch settings.
Use the SRC WCLK DIP switches on the RSio64-D to set the SRC clock sent to the Mini-YGDAI card inserted
in the slot.
⑤ SLOT1～4 [SRC] buttons
Used to turn SRC on/off at both IN and OUT for each slot.
⑥ WORD CLOCK source
Indicates the SRC word clock source status for slots 1 to 4 the RSio64-D.
SLOT
When using the word clock signal being input from the card in the slot.
WCLK IN
When using the word clock signal being input from the WORD CLOCK IN
connector on the rear panel.
----
If there is no card in the slot.
⑦ WORD CLOCK select button
Used to select the word clock source for the RSio64-D.
 WORD CLOCK WCLK IN indicator
 WORD CLOCK SLOT1 1/2 indicator
 WORD CLOCK DANTE indicator
Indicates the word clock source status for the RSio64-D.
WCLK
IN
On when using the word clock signal being input from the WORD CLOCK IN
connector on the rear panel of the RSio64-D. Flashes
*1
if there is no valid word clock
input.