User Manual

◦ [OK] button
Saves the settings and closes the dialog box.
◦ [Cancel] button
Closes the dialog box without saving the changes.
•
DCP
Select the DCP that has been connected to the DCP port.
The [DCP] dialog is displayed from the , which is displayed when the property Value field is clicked.
For details, refer to the "DCP" chapter.
•
PGM1 (MTX5-D only)
Specify the Unit ID for the PGM1 that is controlling the MTX5-D.
The [PGM1] dialog is displayed from the , which is displayed when the property Value field is clicked.
For details, refer to the "Workflow for paging settings".

Because the PGM1 settings are stored by the MTX5-D, it is normally not necessary for
ProVisionaire Design to discover the PGM1.
When using ProVisionaire Design to update the PGM1 firmware or change the IP address,
please install Bonjour Print Service to allow ProVisionaire Design to discover the device.
14. Audio Processors : MTX5-D/MTX3
ProVisionaire Design User Guide | 177