User Manual

[MTX Level / MTX Send Level]
When you press the switch, the assigned parameter is automatically assigned to the knob and can be operated
with the knob.
This function is only for DCP1V4S.
If you assign this to a switch, the knob will say "Occupied by sw" and will not be assignable to any other
parameter. Refer to the Knob section for parameters.
[MTX Level Inc/Dec / MTX Send Level Inc/Dec]
•
[Inc]
If this is selected, the value increases when the switch is pushed.
You can set the movable range with Upper Limit/Minimum.
•
[Dec]
If this is selected, the value decreases when the switch is pushed.
You can set the lower limit with Lower Limit.
◦ [Mute Enable] check box
If this option is selected, the Mute state (–∞ dB) will be enabled if the level is lowered below the
value specified by [Lower Limit].
•
[Sensitivity] list box
Sets the sensitivity of parameter changes in response to the downward operation of the DCP switch.
26. DCP
336 | ProVisionaire Design User Guide