User Manual

13.7.5. Duplicating an input port name
If you want to use the signal name as the port name, it is convenient to duplicate the port name.
Here we explain how to automatically duplicate the input port name.
In general, the input port name is automatically duplicated to the input port of the connection destination
component, but the following exceptions apply.
• For a mixer-type component or a component that has only an output, the output port name is duplicated
to the input port of the connection-destination.
• If the duplication-source port name is blank, it is not automatically duplicated.

If the port name has already been specified, the port name is overwritten by the automatic
duplication.
•
Automatically duplicating the port name when components are connected
If [Tools] menu → [Duplicate Port Label] has a check mark, the port name is automatically duplicated
when you make a connection between components.
•
Duplicating the port name of components along the signal path
In the context menu that appears when you right-click a port or component, choose [Duplicate Port Label -
to the right] or [Duplicate Port Label - to the left]; the input port name is duplicated to the input port of the
following or preceding components.
However if a mixer-type component exists within this path, duplication stops at the mixer-type
component.
13. Audio Processors: DME7
ProVisionaire Design V1.2 User Guide | 131