User Manual

13.15.2. "Remote Control Setup List" dialog box
To open this dialog box, click [Remote Control Setup List] from the [Tools] button in the “Device” sheet.
To control or monitor the DME7 using the SCP or YOSC communication protocol, you must register the
parameters or meters to the Remote Control Setup List.

For more information on communication protocols, refer to the “DME7 Remote Control
Protocol Specifications” or “DME7 OSC Specifications” that are posted on the Yamaha Pro
Audio website.
■ Registering parameters or meters to the list
You can register parameters or meters to the lists using one of the following methods:
Registration source Registration method
Design sheet While pressing and holding down < Ctrl >, drag and drop a
component to the list.
Right-click a component, and then select [Add to Remote Control
List].
Component editor/
Parameter setting window
【Parameter】
While pressing and holding down < Ctrl >, drag and drop a
parameter to the list.
Right-click a parameter, and then select [Add to Remote Control
List].
【Component】
Right-click anywhere other than a parameter, and then select [Add
to Remote Control List].
“Parameters” area*1
Drag and drop a component or parameter to the list.
Right-click a component or parameter, and then select [Add to
Remote Control List].
*1. You can also use < Shift > or < Ctrl > to simultaneously register multiple parameters in a list.
13. Audio Processors: DME7
158 | ProVisionaire Design V1.2 User Guide