User Manual

◦ Emergency mode
The DME7 enters Emergency mode if it receives the SCP devmode emergency command, or when
the input at [GPI IN] connector (IN 16) (which supports +24V) falls below 2.5V.
In this mode, the unit will operate as follows.
▪
The unit recalls the snapshot that was specified for [Emergency Recall] which can be
accessed from [Parameter Sets]. When Emergency mode is cleared, the device returns to
the status obtained prior to recall.
▪
Operations from an external controller such as a DCP will no longer be received.
▪
The unit will be taken offline from ProVisioniare Design.
■ Input Type
Connection examples using the [GPI IN] connector
•
Connection example 1:
Controlling the DME7 with a switch
•
Connection example 2:
Controlling the DME7 with a 10kΩ B-curve variable resistor
• [INPUT TYPE] allows the following settings.
◦
Analog
◦
Analog Inv.
◦
High Active
◦
Low Active
◦
Rising Edge
◦
Falling Edge
13. Audio Processors: DME7
168 | ProVisionaire Design V1.2 User Guide