User Manual

14.9. Parameter Sets Area
A collection of parameters being stored/recalled in a snapshot is called a parameter set. By storing a snapshot,
the current values of parameter set members are saved. A single parameter set can store 10 snapshot patterns.
A single parameter can be registered to multiple parameter sets.
Snapshots can be controlled using an external controller by assigning them to the Remote Control Setup List.
Note that snapshots cannot be recalled from the front panel of the main unit (only presets can be recalled).
In the Presets area, click on [Recall Settings] to register the snapshot to a preset.
The following methods are available for registering to a parameter set.
Registration Source Registration Method
Design Sheet While holding the < Ctrl > key down, drag & drop the component into the
Parameter Set name.
Right-click on the component and select the parameter set to be
registered using [Add to Parameter Set].
Component Editor While holding the < Ctrl > key down, drag & drop the parameter into the
Parameter Set name.
Link Control Editor While holding the < Ctrl > key down, drag & drop the Link Control into the
Parameter Set name.
Parameters Area*1 Drag & drop a component or parameter into the Parameter Set name.
Right-click on the component or parameter and select the parameter set
to be registered using [Add to Parameter Set].
Parameter Sets Area After selecting the parameter set to register, click the [Add Device] button
to register all components placed at that point in time.
*1. Multiple components and parameters can be registered to a parameter set simultaneously by pressing < Shift
> and < Ctrl > together.
14. Audio Processor MRX7-D
194 | ProVisionaire Design V1.2 User Guide