User Manual

14.16.2. Remote Control Setup List Dialog
Click [Remote Control Setup List] from the [Tools] button in the device sheet to open this dialog.
The MRX7-D can be controlled from an external device using the Dante [PRIMARY]/[SECONDARY] terminal or the
[RS-232C] terminal.
To control or monitor from an external device, parameters, meters, snapshots, and snapshot groups must be
registered in the Remote Control Setup List.

Configure the external device according to the "MTX3 MTX5-D MRX7-D XMV Series EXi8 EXo8
Remote Control Protocol Specifications."
● Remote Setup Tab
Two methods are available for registering to the list.
Registration Source Registration Method
Design Sheet While holding the < Ctrl > key down, drag & drop the component
into the list.
Right-click the component and select [Add to Remote Control List].
Component Editor/
Parameter Setting Window
[Parameters]
While holding the < Ctrl > key down, drag & drop the parameter into
the list.
Right-click the parameter and select [Add to Remote Control List].
[Components]
Right-click a location outside the parameter and select [Add to
Remote Control List].
Parameters Area*1
Drag & drop components or parameters into the list.
Right-click a component or parameter and select [Add to Remote
Control List].
Parameter Sets Area
Drag & drop snapshots into the list.
Drag & drop snapshot groups into the list.
14. Audio Processor MRX7-D
206 | ProVisionaire Design V1.2 User Guide