User Manual

◦
1st Priority Mix Level
◦
2nd Priority Mix Level
◦
Input Ch DCA Group
◦
ZONE Out DCA Group
◦ [Parameter1]
Specify the channel that will be used to control the [GPI OUT] connector.
◦ [Output Type]
Specifies how output will occur from the [GPI OUT] connector.
•
[MTX Send Level]
You can use this to fader-start a CD player, or to light an indicator when high volume occurs. Select one of
the following parameter types, and then make the appropriate setting.
◦
Input Ch Send Level
◦
Fx RTN Send Level
•
[Alert]
A signal will be output to the [GPI OUT] connector when an alert occurs.
◦ [Parameter1]
Select the type of alert from the following. For details on the type of alert that is output, refer to
“Alert list”.
▪
Fault, Error, Warning
▪
Fault, Error
▪
Fault
◦ [Output Type]
Only Closed can be selected. If an alert is occurring, the [GPI OUT] connector will be closed. The
closed state will continue until the alert has been cleared.
15. Audio Processors: MTX5-D/MTX3
244 | ProVisionaire Design V1.2 User Guide