User Manual

◦ Off:
No Dereverberation function. For use with external signal processing of a conference application or
an external DSP.
◦ Low:
Select this setting for minimal Dereverberation for rooms with good acoustics and low
reverberation times.
◦ Medium:
Default setting used for most rooms and is a good balance between Dereverberation and sound
quality.
◦ High:
Select this mode for maximum Dereverberation for rooms with poor acoustics and long
reverberation times. (e.g. glass walls & other reflective surfaces)
•
AGC type
Set strength of the auto gain control to reduce the fluctuation of the voice level, which is sent to remote
listeners on the line.
◦ Off
Select this setting to disable automatic volume adjustment or to use another auto gain control of a
conferencing application or an external device.
◦ Low
Default setting. Produces a natural sound level. Low talker volume input will remain low. High talker
volume will be attenuated if it is too loud.
◦ High
elect this setting to compensate for high dynamic talker volume changes. This setting will increase
the volume level of quiet talkers in the room and will attenuate volume output if it is too loud.
•
AGC speed
Set the reaction speed of the volume change of the auto gain control.
◦ Low:
Default setting and general well-balanced setting between volume change and effect.
◦ High:
Select this setting for faster volume level compensation.
•
Enable Low latency mode
Select this option for applications that require short audio delays, such as voice lifts.
All signal processing on Ch2 (lower output of the DSP Settings component) is disabled.
24. Microphones: RM-CG
ProVisionaire Design V1.2 User Guide | 357