User Manual

example by specifying the center LED as the volume setting for normal use and setting the maximum
value to the maximum volume that is allowable for the system, you can prevent damage to the system
that might occur if the volume of the background music were raised during a noisy time.
If the check box is selected, the Nominal function will be on.
[Nominal Value] specifies the nominal value.
[Nominal LED Position] specifies the LED position that will light when the level reaches the nominal value.
•
[Sensitivity]
Sets the sensitivity of parameter changes in response to the rotary operation of the DCP knob.
If [Acceleration] is on, the parameter will change faster if the knob is rotated more rapidly. If [Fast] is
selected as the [Sensitivity], the [Acceleration] setting is dimmed and unavailable.
27.3.3. [Dimmer & Lock] tab
Sets the brightness of the MCP1’s display and switches, and the operation of the panel lock.
•
[LED Brightness] list box
Specifies the brightness of the DCP unit’s LEDs. Higher values will make the LEDs brighter.
◦ [Enable Inactive Mode] check box
If the check box is selected, the unit automatically enters inactive mode after a time duration
specified in [Waiting Time].
[Inactive LED Brightness] specifies the brightness of the LEDs when inactive.
If the check box is cleared, the drop-down menu is grayed-out and you will be unable to set the
brightness.
•
[Panel Lock] check box
If this check box is selected, the DCP panel will be locked when the snapshot library is recalled.
If the [Enable Temporary Unlocking] check box is selected, pressing and holding down DCP switch 1 for
two seconds will unlock the panel.
•
[Waiting Time]
Specifies the time from the last operation until the unit enters inactive mode or the panel is locked.
27. DCP
376 | ProVisionaire Design V1.2 User Guide