User Manual

27.4. Setting method for MTX5-D/MTX3
When the DCP component in MTX5-D/MTX3 is clicked, the DCP dialog opens and settings can be made.
27.4.1. DCP component settings
Double-click the DCP component to open the component editor.
•
[Library]
You can store 32 sets of DCP settings in the Library.
The Library stores the settings of all DCPs connected to the MTX. Also, the DCP Library can be recalled at
the same time as the MTX preset recall. Make settings in the dialog box that appears when you press the
[Recall Settings] button in the “Presets” area.

The library can be used on the DCP by recalling it at the same time as the MTX preset.
If you want to select the DCP to recall, click the [Recall Filter] button in the “Presets”
area and make filter settings in the dialog box that appears.

Recalling the Library will collectively recall all DCPs (up to 8 units) connected to the
MTX.
When recalling a Library, any desired DCP can be excluded from the recall.
Click on the Recall Filter button in the Presets area and set the filter in the dialog that
appears.
◦ [Save] button
This button stores an item in the library.
The [Parameter Assign] tab and [Dimmer & Lock] tab settings will be saved.
◦ [Load] button
Load Library.
Expand the settings to the "Parameter Assign" tab and the "Dimmer & Lock" tab.
27. DCP
ProVisionaire Design V1.2 User Guide | 377