User Manual

28.3. Setting Method
1.
Double-click the MCP1 placed on the Project sheet.
Component Editor will be displayed.
2.
Click on the [Controlled Devices] button in the Component Editor.
The Controlled Devices dialog will be displayed.
On this screen, register the devices to be controlled by the MCP1.

For devices with fixed configurations, such as the MTX5-D and PC-D series, the device
does not necessarily need to be placed on the Project sheet.
However, devices such as the DME7 and MRX7-D, whose configurations can be freely
changed by the user, must be placed on the Project sheet. This is to assign parameters
by dragging and dropping them from the Component Editor of the device sheet, the
Parameter Sets area, etc.
28. Wall-mount Controller: MCP1
396 | ProVisionaire Design V1.2 User Guide