User Manual
Table Of Contents
MCP1 Remote Control Protocol Specifications V1.0.0
4
1. Setup
1.1. Connection Procedure
Ethernet
Remote Controller
Network
Switch
MCP1
Ethernet
1.2. Configuring the Remote Controller
MCP1 can be controlled from an external controller through the Ethernet (NETWORK) connector.
IP Address: Specify the IP address of the device to be controlled.
TCP Port: 49280
1.3. Device Configuration
Up to eight remote controller devices can connect simultaneously to an MCP1.
When recalling a preset between MCP1s, the MCP1 performing a recall is regarded as a remote controller.