User Manual

4.8. Testing operation
Let’s operate the widgets on each page to verify that they work. We assume that there is a device that is being
controlled.
1. Power-on the device.
2. Connect the computer to the network that is connected to the device’s NETWORK port.
3.
On the title bar, click the [Setup] button .
The “Setup” dialog box opens.
4. Select the network interface card that is connected to the network that is connected to the device’s
NETWORK port.
NOTE
Up to eight network adapters can be selected at the same time.
5.
Click the [OK] button.
The dialog box closes.
6. In the “Controllers” area, select the controller that you want to operate.
7.
On the tool bar, click the [Run] button .
Kiosk starts.
The operation when a controller file is loaded in Kiosk can be checked.
8.
Note that the indication “All Devices are ONLINE” is shown in the upper right.
If this indicates “All Devices are OFFLINE,” then Kiosk has not detected the devices. Make sure that the
network settings of the devices and the computer are correct.
9.
Click the button labeled “DM7.”
The page changes.
4. Basic process
28 | ProVisionaire Control PLUS V1.0 User Guide