User Manual

Procedure
1.
With the device in an online state, turn the probe monitor function ON.
The cursor changes to the probe shape.
2. By clicking on any of the output ports for the component, the probe is set as the monitoring
point "Monitor1."
The monitoring point can be moved by clicking on a different output port.
The monitoring point is removed by clicking again on the selected port.
Holding <Shift> key on the computer keyboard while clicking on an output port sets the probe as
monitoring point 2.
Moving and removing the monitoring point is the same as for Monitor1.
The red probe is the point monitoring for Monitor1, the yellow probe is monitoring for Monitor2,
and the green probe is the location interrupting the oscillator.
3. You can select from Dante Out 1–256 and USB Out 1–8 for the Monitor 1 and Monitor 2 outputs.
Even if audio is originally wired to the above port, it is replaced with the output of the Probe
component.
4. Turn the probe monitor function OFF to cancel the probe. The mouse cursor display returns to
normal.
As long as Probe is not set to OFF, the Probe will not be canceled, even if the Probe component
window is closed.
2.38.2. Control
Parameter types of the input/output values for each Port
Input Value Control Parameter Output Value
Type Range Input
Port
Name
Paramete
r Range
Output
Port
Name
Type Range
Value Num 0,1 ● On
OFF:0,
ON:1
● On Value Num
OFF:0,
ON:1
2. Audio Components
108 | ProVisionaire Design Component Guide