User Manual

[VCM] Compressor 260
Compressor 260 emulates the characteristics of a compressor and limiter that were widely used in the
mid-1970s.
This plug-in operates in mono or stereo mode, depending on the channel configuration of the rack.
[THRESHOLD] Knob
Sets the level at which compression is applied. Only signal levels that are above the set
threshold are processed.
[KNEE] Switch
Sets how fast compression is applied. When set to [SOFT], the compression ratio increases
slowly as the level increases, and when set to [HARD] it is compressed immediately.
[ATTACK] Knob
Sets the time it takes for Compressor 260 to respond to a signal level that is above the
threshold. The longer the [ATTACK] time, the greater the amount of signal (attack) that passes
unprocessed.
[RELEASE] Knob
Sets the time it takes for the gain to return to the original level when the signal drops below
the threshold.
[RATIO] Knob
Adjust the ratio. Turn the control to the right to increase the compression ratio. If you turn it
completely to the right, the plug-in will operate as a limiter.
[OUTPUT] Knob
Adjusts the output gain.
[GR] Meter
Displays the amount of gain reduction applied by the plug-in.
[OUT] Meter
Displays the output level of the effect.
Dynamics Plug-ins
68 | VST Rack Pro Plug-in Reference