User Manual

RUio16-D Owner’s Manual
10
4 [PEAK] indicators
This indicator lights when the volume
of the input sound is too high (when it
is only 3 dB before clipping). If the
indicator lights frequently, turn the
[GAIN] knob to the left to lower the
volume.
5 [+48V] switch
Turns the phantom power (+48V) on
(lit) or off (unlit). When you turn this
switch on, phantom power will be
supplied to the XLR jack connected to
the INPUT [CH15]/[CH16] jacks. Turn
this switch on when using a phantom
powered condenser microphone.
NOTICE
When using phantom power, observe the
following to prevent this unit or any external
devices from malfunctioning, or from noise
being generated.
• Do not connect or disconnect any devices
while the phantom power switch is turned
on.
• Set the [OUTPUT] knob to the minimum
setting before turning the phantom power
switch on/off.
• When connecting devices not requiring
phantom power to the INPUT [CH15]/
[CH16] jacks, make sure to turn the
phantom power switch off.
NOTE
When the phantom power switch is turned on/
off, the input signals from INPUT [CH15]/
[CH16] will be muted for several seconds.
6 [USB] indicator
This indicator lights up when the power
is turned on and the unit is able to
communicate with the computer. The
indicator blinks when the unit cannot
communicate with the computer.
7 [MONITOR/DANTE/USB]
switch
This switch lets you select the signal to
be output to the OUTPUT jacks.
If the unit is not connected to a
computer, the [USB] setting outputs
the Dante 15/16 or INPUT 15/16
signals, and the [MONITOR] setting
outputs the INPUT 15/16 signals.
8 [DANTE 15-16] switch
This switch lets you select the signal to
be output to the PHONES jack.
If the unit is not connected to a
computer, the INPUT 15/16 signals are
output when this is switched off.
9 [BYPASS USB] switch
When this is turned on, input/output to
and from the computer will be
bypassed and the audio will be output
as-is without going through the
computer. This reduces noises that
may occur if VST Rack has stopped
operating or if incorrect audio data has
been output due to a problem with
your computer.
The switch will light red when bypass
is active.
MONITOR USB from PC (MONITOR L/R
(17/18))
DANTE Dante input 15/16
USB USB from PC 15/16
Switched on Dante input 15/16
Switched off USB from PC (MONITOR L/R
(17/18))