User Manual
Table Of Contents
- PRECAUTIONS
- Contents
- Introduction
- Main Features
- Panel Controls and Functions
- Before Using This Product
- Basic Operations
- How to Connect via Dante
- Attaching the Cable Hook
- Attaching the Rubber Feet
- Installing in a Rack
- Restoring the Factory Default Settings (Initialization)
- Messages
- General Specifications
- Dimensions
RUio16-D Owner’s Manual
18
Attaching the Cable Hook
Use the following steps to attach the cable hook that is included with this product, if
you will use it. The cable hook helps prevent the USB cable from being accidentally
yanked out during recording or in other situations.
1. Insert one of the tips of the cable hook that is included with this unit into
the bottom part of the security slot, located at the center of the rear panel.
2. Squeeze the other side of the hook and insert the other tip into the top part
of the security slot.
3. Thread the USB cable through the cable hook, and plug the USB connector
into the USB port.
Twist the screws clockwise on the USB cable to lock it in place.
Attaching the Rubber Feet
Attach the rubber feet onto this product if you will be using it on a table or platform
with a slippery surface.
Attach the rubber feet in the positions shown in the illustration, and place the unit on
a level surface.
Rubber feet
Guides for attaching
the rubber feet