User Manual

RUio16-D Owner’s Manual

Installing in a Rack

You can install this unit onto a standard 19-inch rack shelf, using screws to hold it in

place.

Have ready two small M4 screws with a 0.7 mm pitch and a length of 6 mm. Line the

threads of the screws up with those of the screw holes at the bottom of this unit, and

install the screws into the panel. Check the dimensional drawing for the hole

positions.

NOTICE

• The rubber feet should not be attached when using screws to hold the RUio16-D in place.

• Make sure that the mounted screws are sufficiently tightened.

NOTICE

This unit is rated for operation at ambient temperatures ranging from 0 to 40 degrees Celsius.

When mounting the unit with other devices in a rack, the heat generated from other devices

can cause the overall temperature inside the rack to rise, which may have an adverse effect on

the performance of this unit. Be sure to observe the following requirements when rack-

mounting this unit to avoid heat buildup:

• When mounting the unit in a rack with devices such as power amplifiers that generate a

significant amount of heat, leave at least 1U of space between this unit and other equipment.

Also, either leave the open spaces uncovered or install appropriate ventilating panels to

maintain sufficient air flow.

114.4

121

5743

Units: mm

Bottom of this unit

M4 screw hole positions