User Manual
Table Of Contents
- PRECAUTIONS
- Contents
- Introduction
- Main Features
- Panel Controls and Functions
- Before Using This Product
- Basic Operations
- How to Connect via Dante
- Attaching the Cable Hook
- Attaching the Rubber Feet
- Installing in a Rack
- Restoring the Factory Default Settings (Initialization)
- Messages
- General Specifications
- Dimensions
RUio16-D Owner’s Manual
20
Restoring the Factory Default Settings
(Initialization)
Follow the steps below to initialize this device if you wish to reset the parameters
configured using VST Rack or reset the Dante Broadway settings to their factory
defaults.
1. Unplug the USB cable from the [5V DC IN] and [USB 2.0 (PC)] ports, and
turn off the power.
2. Insert the USB cable while holding down the
[BYPASS USB] switch on the front panel of this
unit.
All indicators on the front panel will flash while
initialization is in progress.
Once initialization is finished, all indicators will go dark,
and then return to their normal lit status.
The following parameters will change as a result of
initialization.
Messages
Errors, warnings, and other information messages on the RUio16-D are displayed
via the front panel indicators.
Error message
Parameter Setting
Dante Device ID 1
Bypass enable/disable Enabled
[SYSTEM]
indicators
Description Status
An internal error has occurred. The device has failed. Contact your
Yamaha dealer for repair.
Communication cannot occur
because the MAC address
setting has been corrupted.
Flashes red x2
Flashes red x3