User Manual
Table Of Contents
- Contents
- What you can do using ProVisionaire Control
- Operating requirements of the software
- Terms and concepts to understand
- Installation procedure
- Screen structure
- Basic process
- Start up, and register devices
- Placing widgets on a page
- Labeling widgets for easier recognition
- Adding a page
- Specifying a background for the page
- Adjusting the placement of the widgets
- Saving the project file
- Testing operation
- Making security settings
- Creating a controller file
- Making KIOSK start automatically
- Adding parameters or meters for an MTX/MRX system
- Functions specific to initial mode
- Title bar
- Menu bar
- Tool bar
- “Controllers” area
- “Devices” area
- “Widgets” area
- Work area
- “Properties” area
- Widgets
- Dialog boxes and windows
- “Setup” dialog box
- “New Project Wizard” dialog box
- “Add Controller” dialog box
- “Run Controller File” dialog box
- “Import Controller File” dialog box
- “Select Controllers to Import” dialog box
- “Export Controller File” dialog box
- “Imported Images” dialog box
- “Add Device” dialog box
- “Target Editor” dialog box
- “Edit Text” dialog box
- “Edit Device Identifier” dialog box
- “Select Image” dialog box
- “Style” dialog box
- “System Monitor” window
- “ProVisionaire Monitoring Service Settings” view
- Specifying the IP address
- Tips
- Troubleshooting
104
Specifying the IP address
Using the following procedure, specify the IP address of the network
interface card of the computer to which the devices are connected.
1. Open “Network Connections.”
In the search box located at the right of the start button, or in Cortana,
enter ncpa.cpl, and open “Network Connections.”
2. Right-click the interface card that you want to connect
to the system, and choose [Properties].
3. Click [Internet Protocol Version 4 (TCP/IPv4)], and
then click the [Properties] button.
4. Select the [Use the following IP address] radio button.
5. Specify the IP address and subnet mask.
If the device’s IP address is 192.168.0.x, specify an IP address such
as 192.168.0.250 for the same subnet, setting the subnet to
255.255.255.0.
If you want to use a different address, contact the network administra-
tor for the IP address and subnet mask values that can be used.
6. Click the [OK] button.
Close the [Internet Protocol Version 4 (TCP/IPv4) Properties] dialog
box.
7. Click the [OK] button.
The interface’s “Properties” dialog box closes.
This completes the settings.