User Manual
Table Of Contents
- Copyright
- About Audinate
- Introduction
- Installing Dante Controller
- Dante Basics
- Discovery and auto-configuration
- Device Channels
- Differentiating between input and output channels
- Device Names and Channel Labels
- Routing Audio
- Clock Synchronization
- Latency
- Device Lock
- Dante Control and Monitoring
- Starting Dante Controller
- Using Dante Controller
- Network View
- Status Bar
- Network View Tabs
- Channel Groups
- Clock Status Monitoring
- Clock Status Monitor
- Automatic Notification of Device Errors
- Device View
- Device View Tabs
- Multicast Transmit Flow Configuration
- Using Dante Controller with Dante Domain Manager
- Presets
- Troubleshooting
- Fanout
- Messages on Startup
- Computer Configuration Checklist
- Troubleshooting Dante IP Address Configuration
- Troubleshooting Switch Configuration and Cabling
- Index
Dante Controller User Guide
Copyright © 2018 Audinate Pty Ltd. All rights reserved.
-45-
Device State and Configuration Filters
The device state and configuration filters can be expanded and collapsed using the plus [+] and minus [-]
icons.
To filter devices for a particular condition or set of conditions, just select the required checkbox or
combination of checkboxes.
Use the Clear All button to clear the selections from all filters.
Device Lock Filter
Use the Device Lock filter to display devices with a specific lock state.
n To display only locked devices, select the 'Locked' checkbox.
n To display only unlocked devices, select the 'Unlocked' checkbox.
n To display locked and unlocked devices, select both the 'Locked' and 'Unlocked' checkboxes.
n To display devices that do not support Device Lock, select the 'Unsupported' checkbox.
Sample Rate Filter
Use the Sample Rate filter to display devices with a specific sample rate setting.
n To display only devices with a particular sample rate, select the appropriate checkbox.
n To display only devices with one of a selection of sample rates, click the appropriate checkboxes.
Sync to External
Use the Sync to External filter to display devices with a specific Sync to External setting.
n To display only devices with Sync to External enabled, select the 'Enabled' checkbox.
n To display only devices with Sync to External disabled, select the 'Disabled' checkbox.
n To display devices with either setting, select the 'Enabled' and 'Disabled' checkboxes.
n To display devices that do not support Sync to External, select the 'Unsupported' checkbox.
Latency
Use the Latency filter to display devices with a specific latency setting.