User Manual
Table Of Contents
- Copyright
- About Audinate
- Introduction
- Installing Dante Controller
- Dante Basics
- Discovery and auto-configuration
- Device Channels
- Differentiating between input and output channels
- Device Names and Channel Labels
- Routing Audio
- Clock Synchronization
- Latency
- Device Lock
- Dante Control and Monitoring
- Starting Dante Controller
- Using Dante Controller
- Network View
- Status Bar
- Network View Tabs
- Channel Groups
- Clock Status Monitoring
- Clock Status Monitor
- Automatic Notification of Device Errors
- Device View
- Device View Tabs
- Multicast Transmit Flow Configuration
- Using Dante Controller with Dante Domain Manager
- Presets
- Troubleshooting
- Fanout
- Messages on Startup
- Computer Configuration Checklist
- Troubleshooting Dante IP Address Configuration
- Troubleshooting Switch Configuration and Cabling
- Index
Dante Controller User Guide
Copyright © 2018 Audinate Pty Ltd. All rights reserved.
-6-
View 64
Help 64
Device View Toolbar 64
Device View Tabs 65
Receive Tab 65
Receive Channels 65
Flows 66
Available Channels 66
AES67 Flows 67
Creating Subscriptions 67
Changing Receive Channel Labels 67
Transmit Tab 67
Changing Tx channel labels 68
Status Tab 68
Device Information 69
Dante Information 69
Clock Synchronization 70
Primary Interface 70
Secondary Interface 71
Latency Tab 71
About Latency and Packet Loss 71
About the Histogram 72
Interpreting the Histogram 73
Device Config Tab 74
Configurable Parameters 75
Rename Device 75
Sample Rate 75
Preferred Encoding 76
Unicast Delay Requests 76
Device Latency 76
Reset Device 76
Network Config Tab 77
Dante Redundancy / Switch Configuration 78
Redundant 78
Switched 78
Switch Configuration 78
Addresses 78
AES67 Config 79
AES67 Mode 80
Tx Multicast Address Prefix 80
Controls Tab 80