Service manual

ENG
4-49
11.Adjust:
• Push lever position
a. Loosen the locknut .
b. Turn the adjusting screw in or out until
the marks are aligned.
c. Hold the adjusting screw to prevent it from
moving and then tighten the locknut to
specification.
CAUTION:
Do not overtighten the locknut since this
will remove the free play between both
push rods.
12.Check:
• Clutch cable free play
Refer to “ADJUSTING THE CLUTCH
CABLE FREE PLAY” in chapter 3.
13.Install:
•Spacer
• Dowel pin
• Crankcase cover gasket
14.Install:
• Right crankcase cover
15.Install:
• Crankcase cover bolts M6 × 50 mm
,
• Copper washers to ,
• Crankcase cover bolts M6 × 40 mm ~
• Crankcase cover bolts M6 × 25 mm ~
• Oil filter element cover bolt M6 × 70 mm
16.Tighten:
• Crankcase cover bolts
~
• Oil filter element cover bolt
N
O
TE:N
O
TE:
Tighten the bolts in stages, using a crisscross
pattern.
8 Nm (0.8 m•kg, 5.9 ft•lb)
Clutch lever free play
5 ~ 10 mm (0.20 ~ 0.39 in)
Crankcase cover bolt
10 Nm (1.0 m•kg, 7.4 ft•lb)
Oil filter element cover bolt
10 Nm (1.0 m•kg, 7.4 ft•lb)
CLUTCH