Service manual

INSTALLING I/O CARDS
SREV1
16
This section explains how to install mini YGDAI cards in the SREV1.
1. Turn off the SREV1.
2. Undo the two fixing screws and remove the slot cover, as shown below.
Keep the cover and fixing screws in a safe place for future use.
3. Insert the card between the guide rails and slide it all the way into the slot, as shown below. You may have to
push firmly to plug the card into the SREV1 connector.
4. Secure the card using the attached thumbscrews. Do not leave the thumb-screws loose, as the card will not be
grounded correctly.