Service manual

6. Upgrading
6-1. Upgrading SREV1 (using a PCMCIA card)
(1) Start up SREV1 in the normal manner.
(2) Insert the PC Card with the new version of the application version
“srev1.bin” in it into the PCMCIA slot.
(3) Connect the [SERIAL-1] terminal and the RS-232C terminal on the PC.
(4) Use the PC to start “TeraTerm”.
(5) Select “File” “Send file” from the “TeraTerm menu”.
(6) Select “pcmcia_update.bin” from the “TeraTerm: Send file” dialog box.
(7) Check the option for binary in the “TeraTerm: Send file” dialog box.
(8) Click the “Open” button in the “TeraTerm: Send file” dialog box.
Then, the “TeraTerm: Send file” dialog box closes, and then the following
message will appear to shown that the version has been upgraded. It takes
approximately 15 seconds to perform the upgrade.
Once the upgrade has been completed, the system will automatically reboot.
*) Download “srev1.bin” and “pcmcia_update.bin” from the YSISS home
page and save in the PC card.
*) The contents of pcmcia_update.bin are as shown below.
F0 43 74 1E 07 11 00 00 7F 00 00 00 70 F7 (Binary Data 14bytes)
*) If there is absolutely no response from SREV1, the problem is with the
connection.
Check the cables and other connections.
6-2. Upgrading RC-SREV1
SREV1 application file “srev1.bin” there is a execution module for RC-SREV1.
When RC-SREV1 and SREV1 are connected and the version of RC-SREV1
is not compatible with the version of SREV1, the following message will
appear on the screen for RC-SREV1.
Push any key to start the download from SREV1 to RC-SREV1 to perform
the upgrade .It takes approximately 3.5 minutes from the time the key is
pushed until the upgrade is completed. Once completed, RC-SREV1 will
automatically reboot.
IN
Optical Cable
for ADAT
OUT
DO1.2 - DI1.2
DO3.4 - DI3.4
DO5.6 - DI5.6
DO7.8 - DI7.8
LRCKO - LRCKI
EMPO - EMPI
FS0O - FS0I
FS1O - FS1I
1 - 13
2 - 12
3 - 11
4 - 10
5 - 9
18 - 21
6 - 8
19 - 20
7, 14, 15, 16, 17, 22, 23, 24, 25
GND
MY8-TD
13 1
14
25
MY8-AE
Version up from PCMCIA
delete a:srev1.bin.bak
rename a:srev1.bin a:srev1.bin.bak
copy c:srev1.bin a:srev1.bin
done.
Reboot SREV1
* tp
VERSION MISMATCH
PUSH ANY KEY TO DOWNLOAD
SREV1
43