Service manual

[330]: Bind Head Tapping Screw-B SP 3.0X10 MFZN2BL (VH741100) [350]: Bind Head Tapping Screw-B SP 3.0X10 MFZN2BL (VH741100)
[330]
[350]
Fig. 1
Side pad (L)
Side pad (R)
<Left Side View> <Bottom View>
Fig. 3
[310]: Bind Head Tapping Screw-B 3.0X8 MFZN2BL (EP600190)
Fig. 2
[310]: Bind Head Tapping Screw-B 3.0X8 MFZN2BL (EP600190)
[310] [310] [310]
Bottom cover
[310]
Left side: 4pcs
Right side: 4pcs
1. Side Pad (L), Side Pad (R)
(Time required: about 3 minutes)
1-1 Remove the two (2) screws marked [330]. The left side
pad can then be removed. (Fig. 1)
1-2 Remove the two (2) screws marked [350]. The right side
pad can then be removed. (Fig. 1)
2. Bottom Cover (Time required: about 5 minutes)
2-1 Remove the left and right side pads. (See procedure 1.)
2-2 Remove the ten (10) screws marked [310]. The bottom
cover can then be removed. (Fig. 2, 3, 4)
3. REM 1/6 Circuit Board, Power Inverter Unit
3-1 Remove the left and right side pads. (See procedure 1.)
3-2 Remove the bottom cover. (See procedure 2.)
3-3
REM 1/6 Circuit Board (Time required: about 10 minutes)
Remove the two (2) jack sockets marked [170], the screw marked
[180], the screw marked [190] and the two (2) screws marked
[200]. The REM 1/6 circuit board can then be removed. (Fig. 4, 5)
3-4
Power Inverter Unit (Time required: about 8 minutes)
Remove the two (2) screws marked [220]. The power inverter
unit can then be removed. (Fig. 5)
DISASSEMBLY PROCEDURE
RC-SREV1
10