Service manual
RC-SREV1
24
• End
Press the [ENTER] key to return to the menu screen.
3-1-2-6. Fader Test
• Outline
Inspect the motor fader.
• Screen example
• Description
Change the movement distance and driver voltage of each fader and
measure.
• End
Press the [ENTER] key to return to the menu screen.
3-1-2-7. Fader Calibration
• Outline
Motor fader correction is performed.
• Screen example
• Description
After the fader calibration has been automatically performed, measure the
return movement time of each fader is measured. If even one is NG, it will
not be OK. Change the fader or perform “Fader Aging” as needed.
• End
Press the [ENTER] key to return to the menu screen.
3-1-2-8. Comm.Test
• Outline
A check of the REMOTE communication port is performed.
• Screen example
• Description
(1) When “Make Test Loop and Press Enter!” is displayed, connect the loop
back connector jig to the [REMOTE] terminal. After connecting, press
the [ENTER] key to check the status of the connection.
(2) When “Refuse Tx Rs, Press Enter!” is displayed, remove the loop back
connector jig from the [REMOTE] terminal. After removing, press the
[ENTER] key to check the status of the non-connection.
• End
Press the [ENTER] key to return to the menu screen.
3-1-2-9. END
• Outline
Inspection is completed.
• Screen example
• Description
Inspection is completed. At this time, only when all the required inspection
items are terminated and the results are OK will the “All Diag is OK” shown
above be displayed. If the program could not be executed or if there were NG
items, a list of those items will be displayed.
• End
Press the [ENTER] key to return to the menu screen.
<<< Rotally Encoder Test >>>
Push 'ENTER' key to continue
ENCODER ---> :
ENCODER <--- :
OK
OK
OK
<<< RS422 Test >>>
Push 'ENTER' key to continue
Make Test Loop and Press Enter !
Connect Tx Rx OK
Refuse Tx Rx, Press Enter !
NON CONNECT Tx Rx OK
OK
<<< Fader Test >>>
Push 'ENTER' key to continue
-------------------------------------
SPD=0 : 232 236 291 300
SPD=1 : 342 344 404 404
SPD=2 : 592 606 673 661
SPD=3 : 703 709 790 783
-------------------------------------
OK
OK OK OK OK
[0] [1] [2] [3]
<<< .....END Test..... >>>
Push 'ENTER' key to continue
All Diag. is OK !!!
END