User Manual

New reface CS Functions
6
reface CS / reface DX / reface CP / reface YC New Functions
4. Play a key other than the parameter selection keys (C2 to E2) to check the sound. If you need to continue adjusting,
return to Step 2 above.
5. Press the [ ] (Standby/On) switch to turn off the instrument and exit Advanced Settings mode.
In order to avoid changing other parameter settings while playing, be sure to always exit Advanced Settings mode after
changing settings.
Settings made in Advanced Settings mode are retained after you turn off the instrument.
Pitch Bend Range
The Pitch Bend Range function sets, in semitone units, the range over which the pitch can be varied.
Factory default setting: 12 semitones (one octave)
 Setting to 12 semitones or two semitones
1. While holding down the C3 key, set the [ ] (Standby/On) switch to On ( ).
Each time you perform this operation, the pitch bend range toggles between “12” and “2.”
Display when set
NOTE
If you wish to reverse the direction in which the pitch bends, use the Pitch-bend Range Inversion function.
12 Lamps from the LOOPER section light up.
2 Lamps from the LOOPER section flash.
C2 D2 E2
D
#
2C
#
2
Sound produced
Parameter selection keys (C2 to E2)
No sound produced
C3