User Manual

19 En
English
You can set the time until the system automatically enters standby mode.
1 Press SNOOZE/SLEEP a number of times to set
the time until the system enters standby mode.
The sleep timer can be set to 30, 60, 90 and 120 minutes.
When the time is set, the sleep indicator ( ) is shown on the
front panel display.
y
If you press SNOOZE/SLEEP while the sleep timer is activated, the
sleep timer setting will be canceled.
1 Press one of the LOW/MID/HIGH EQ buttons on
the remote control while playing back.
Select the tone to be adjusted (LOW, MID, HIGH).
2 Press / to adjust the tone.
Each tone can be adjusted from –5 to +5.
3 Press to complete settings.
You can also press the EQ button that you pressed in Step 1
to complete the settings.
To change the tone of other frequency band, return to step 1
and press the EQ button to adjust the desired tone.
1 Adjust the brightness with the DIMMER switch on
the rear panel.
AUTO: adjusts the brightness automatically to match the
surroundings.
1: brighter.
2: darker.
Note
When AUTO is set, the brightness of the front panel display is adjusted
automatically with the illumination sensor (☞ P. 3). Ensure that the
sensor is not covered.
USING THE SLEEP TIMER
AUTO SET BEEP
SOURCE
+
BEEP
SOURCE
DIMMER
CLOCK
ALARM TYPE
2
1
2
1
VOLUME
USB LABEL SIDE
SOURCE PRESETALARM SNOOZE
SLEEP
1
Top panel
TONE CONTROL (REMOTE CONTROL ONLY)
1
2
3
Remote control
: HIGH
： MID
： LOW
Tone
Setting
Tone
ADJUSTING BRIGHTNESS OF FRONT PANEL DISPLAY
AUTO21
Rear panel