User Manual

reface CS / reface DX / reface CP / reface YC New Functions

New reface CP Functions

Yamaha has upgraded the reface CP firmware, adding the following new functions.

• Master Tuning

• Master Transpose

• Transmit Channel

• Receive Channel

Master Tuning

The Master Tuning function sets the tuning for the entire instrument (414.8 to 466.8 Hz).

This can be very useful when you wish to tune your reface to the pitch of another instrument or a CD.

Factory default setting: 440.0 Hz

 Setting to either 440.0 Hz or 442.0 Hz

1. While holding down the A3 key, set the [ ] (Standby/On) switch to On ( ).

Each time you perform this operation, the master tuning will toggle between 440.0 Hz and 442.0 Hz.

Display when set

 Adjusting in 0.2-Hz steps

1. While holding down the A3, C#4, and E4 keys, set the [ ] (Standby/On) switch to On ( ). This activates Advanced

Settings mode.

In this mode, all of the [TYPE] lamps light up, and you can change parameters by using the keyboard.

440.0 Hz

The [TYPE] knob’s Clv lamp and the lamps from the TREMOLO/WAH to D.DELAY/A.DELAY

sections light up.

442.0 Hz

The [TYPE] knob’s Clv lamp and the lamps from the TREMOLO/WAH to D.DELAY/A.DELAY

sections flash.

A3 E4