User Manual

New reface YC Functions
22
reface CS / reface DX / reface CP / reface YC New Functions
2. While holding down the C2 key, press a key between A#3 and C#4.
If, for example, you wish to raise the pitch by 1.00 Hz, press the C#4 key five times while holding down the C2 key.
Whenever you press a parameter selection key or a setting key, the lighting condition of the [WAVE] lamps changes
accordingly. No sound is produced during the setting process.
3. Release the C2 key and confirm that all of the [WAVE] lamps light up.
This indicates that your setting has been saved.
4. Play a key other than the parameter selection keys (C2 to D#2) to check the sound. If you need to continue adjusting,
return to Step 2 above.
5. Press the [ ] (Standby/On) switch to turn off the instrument and exit Advanced Settings mode.
In order to avoid changing other parameter settings while playing, be sure to always exit Advanced Settings mode after
changing settings.
Settings made in Advanced Settings mode are retained after you turn off the instrument.
NOTICE
Do not turn off the instrument until all of the [WAVE] lamps have lit up. Failure to observe this precaution can lead
to data becoming corrupted.
B3C2 C4
C
#
4A
#
3
Lower by about 0.2 Hz (-0.2 Hz)
Raise by about 0.2 Hz (+0.2 Hz)
Set to 442.0 Hz
Return to 440.0 Hz
Master Tuning
Setting keysParameter selection keys (C2 to D#2)
C2 D2
D
#
2C
#
2
Sound produced
Parameter selection keys (C2 to D#2)
No sound produced