User Manual

New reface YC Functions
24
reface CS / reface DX / reface CP / reface YC New Functions
4. Play a key other than the parameter selection keys (C2 to D#2) to check the sound. If you need to continue adjusting,
return to Step 2 above.
5. Press the [ ] (Standby/On) switch to turn off the instrument and exit Advanced Settings mode.
In order to avoid changing other parameter settings while playing, be sure to always exit Advanced Settings mode after
changing settings.
Settings made in Advanced Settings mode are retained after you turn off the instrument.
Transmit Channel
The Transmit Channel function sets the MIDI transmit channel.
Factory default setting: Channel 1
 Procedure
1. While holding down the A3, C#4, and E4 keys, set the [ ] (Standby/On) switch to On ( ). This activates Advanced
Settings mode.
In this mode, all of the [WAVE] lamps light up, and you can change parameters by using the keyboard.
2. While holding down the C#2 key, press a key between C3 and E4.
Whenever you press a parameter selection key or a setting key, the lighting condition of the [WAVE] lamps changes
accordingly. No sound is produced during the setting process.
C2 D2
D
#
2C
#
2
Sound produced
Parameter selection keys (C2 to D#2)
No sound produced
A3 E4
C
#
4
off
2 ch 4 ch 5 ch 7 ch 9 ch
11 ch 12 ch 14 ch 16 ch
1 ch 3 ch 13 ch 15 ch 6 ch 8 ch 10 ch
B3C3 D3 E3 F3 G3 A3 C4 D4 E4
C
#
4D
#
4A
#
3G
#
3F
#
3D
#
3C
#
3C
#
2
Setting keysParameter selection keys (C2 to D#2)
Transmit Channel