User Manual
Table Of Contents
- ■ Using the PDF manual
- ■ System Requirements
- ■ Setup
- ■ Operating R Remote
- ■ Uninstalling the software(Removing the application)
- ■ Troubleshooting
R Remote Version 3 User’s Guide 23
SLOT1
1/2
On when using the word clock for channels 1/2 of slot 1 for the RSio64-D. Flashes
*1
if
there is no valid word clock input. When using MY8-AEB
*2
, the word clock for
channels 7/8 is used.
DANTE
On when using the word clock for the Dante network
*3
. (If there is no valid Dante
signal input, the internal Dante module will generate a clock.)
*1 When flashing, Dante word clock
*3
input/output is used.
*2 If you are using MY8-AEB, set the AE⇔ RSVD switch for the card to RSVD.
*3 If you make changes to the frequency of the Dante word clock, use Dante Controller.
⑧ [CURRENT PATTERN] button
If you press this button, the currently selected routing pattern on the RSio64-D is displayed. If you
switch the routing pattern on the RSio64-D, it will be applied in 3 seconds.
⑨ [USER PATTERN] button
Press this button to open the window for setting the audio routing user pattern in the RSio64-D.