User Manual

21.4. Component editors
When you double-click a component in the device sheet, the component editor opens.
This section describes the VXL1-16P component editor, and the dialogs and windows that are closely associated
with the components. For details about other components, refer to the "ProVisionaire Design DME7 Component
Guide"."
Numbe
r
Component name Details Link
①
Dante In Displays the audio signal level for
the 2 channels input from the
[Dante] terminal and adjusts the
gain.
---
②
Compressor Adjusts the compressor that
compresses dynamic range.
"ProVisionaire Design DME7 Component
Guide"
③
Enhancer Sets whether the enhancer is
enabled or disabled. This is a
process that mixes in sounds
beyond the low-frequency and
high-frequency fundamental
tones that are not output from
the speakers to make it sound as
if low-frequency and high-
frequency sounds are being
output.
---
④
Fader Adjusts the signal level of the
input channel.
---
⑤
3 Band EQ Adjusts the 3-band equalizer of
the input channel.
"ProVisionaire Design DME7 Component
Guide"
⑥
Oscillator This outputs a sine wave used to
check the operation of the
connected speakers and the
acoustic characteristics of the
venue.
---
⑦
Ducker w/NG Sets the ducker and noise gate. "ProVisionaire Design DME7 Component
Guide"
⑧
Matrix Assigns input channels and
oscillator outputs to output
channels.
"ProVisionaire Design DME7 Component
Guide"
⑨
10 Band EQ Adjusts the output channel’s 10-
band EQ.
"ProVisionaire Design DME7 Component
Guide"
21. Powered Speakers : VXL1-16P
300 | ProVisionaire Design User Guide