User Manual
Table Of Contents
- ■ Using the PDF manual
- ■ System Requirements
- ■ Setup
- ■ Operating R Remote
- ■ Uninstalling the software(Removing the application)
- ■ Troubleshooting
R Remote Version 3 User’s Guide 11
5. Make the following settings according to the IP address setting you made in "Settings on the R
series units."
AUTO IP or DHCP STATIC IP (AUTO)
Click [Obtain an IP address automatically].
Click [Use the following IP address:]. As the IP
address, enter "192.168.0.xxx (a value in the
range 1 to 254 that does not conflict with any
other device, including the R series units), and
enter "255.255.255.0" as the subnet mask.
The 192.168.0.101 shown below is an example.
If you're using STATIC IP (MANUAL), specify the setting that's appropriate for your network. For
details, consult your network administrator.
6. Click [OK].
Proceed to "Use Dante Controller or the CL/QL series console to specify the routing."