User Manual
10.8. "IP Settings" dialog box
To open this dialog box, click [IP Settings] from the [System] menu on the menu bar.
Lists the devices found on the network, allowing you to change their IP address.
•
Network Interface
Shows the name/IP address/subnet mask of the network card currently selected in the "Network Setup"
dialog box.
•
[Refresh] button
Searches again for devices on the network.
• Device list
◦ Identify button
When you press this button located at the left of the UNIT ID, the indicators of the corresponding
device will flash for several seconds.
◦ Unit ID / Model / Device Name
These columns indicate the device Unit ID, device model name, and device name. If there is a UNIT
ID conflict, an indication is shown.
To change the device name, use the [Device Name] field in the “Properties” area of the “Project”
sheet.
◦ Control Port
Indicates the port name if multiple control ports exist.
◦ IP Settings
Indicates the IP setting type.
◦ IP Address/MAC Address/Subnet Mask/Default Gateway
Indicates the IP address, MAC address, subnet mask, and default gateway that are specified for the
device.
10. Dialog boxes
ProVisionaire Design User Guide | 65