User Manual

Effects Parameters
13 RIVAGE PM series Data List
■ Dynamic Flanger
Two input, two output dynamically controlled flanger.
■ Dynamic Phaser
Two input, two output dynamically controlled phaser.
■ Phaser
Two input, two output 16-stage phaser.
■ Max100
Complete reproduction of a vintage effect that was manufactured only during the late 1970s.
■ Dual Phaser
Complete reproduction of a vintage effect that was manufactured during the middle of the 1970s.
■ Vintage Phaser
Phaser that provides a high degree of soundshaping flexibility, and is not intended as a reproduction of
any specific model.
Parameter Range Description
SENSE 0–100 Sensitivity
DIR. UP, DOWN Upward or downward frequency change
DECAY 3.34 ms–42.7 s Decay speed
OFFSET 0–100 Delay time offset
FB.GAIN –99 to +99% Feedback gain
Parameter Range Description
SENSE 0–100 Sensitivity
DIR. UP, DOWN Upward or downward frequency change
DECAY 3.34 ms–42.7 s Decay speed
OFFSET 0–100 Lowest phase-shifted frequency offset
FB.GAIN –99 to +99% Feedback gain
STAGE 2, 4, 6, 8, 10, 12, 14, 16 Number of phase shift stages
Parameter Range Description
FREQ. 0.05–40.00 Hz Modulation speed
DEPTH 0–100% Modulation depth
FB. GAIN –99 to +99%
Feedback gain (plus values for normal-phase feedback, minus values for
reverse-phase feedback)
OFFSET 0–100 Lowest phase-shifted frequency offset
PHASE 0.00–354.38 degrees Left and right modulation phase balance
STAGE 2, 4, 6, 8, 10, 12, 14, 16 Number of phase shift stages
SYNC OFF, ON Tempo parameter sync on/off
NOTE
*1
*1.
Used in conjunction with TEMPO to determine FREQ.
Parameter Range Description
MODE 1 to 4 Switches the tonal character
SPEED SYNC ON, 0.100 to 10.00 Hz Modulation speed
FOOT OFF, ON Effect on/off
Parameter Range Description
LFO 1 RATE SYNC ON, 0.067 to 20.00 Hz LFO 1 speed
LFO 1 SHAPE SINE, SQUARE LFO 1 waveform
LFO 2 RATE SYNC ON, 0.111 to 20.00 Hz LFO 2 speed
LFO 2 SHAPE SINE, SQUARE LFO 2 waveform
PHASER A DEPTH
(A DEPTH
*1
)
*1. Actual indication in the screen encoder access field
1.00 to 10.00 Modulation depth of Phaser A
PHASER A FEEDBACK
(A FB.
*1
)
1.00 to 10.00 Feedback amount of Phaser A
PHASER A ON/OFF OFF, ON Phaser A on/off
PHASER B DEPTH
(B DEPTH
*1
)
1.00 to 10.00 Modulation depth of Phaser B
PHASER B FEEDBACK
(B FB.
*1
)
1.00 to 10.00 Feedback amount of Phaser B
SWEEP LFO LFO1, LFO2 Phaser B LFO
PHASER B SWEEP TYPE NORM/REV LFO phase of Phaser B
PHASER B ON/OFF OFF, ON Phaser B on/off
MODE 1 to 4 Rearranges the two phasers
Parameter Range Description
SPEED SYNC ON, 0.100Hz to10.00 Hz Modulation speed
MANUAL 0.00 to 10.00 Center frequency of modulation
DEPTH 0.00 to 10.00 Depth of modulation
FEEDBACK 0.00 to 10.00 Feedback amount
COLOR 0.00 to 10.00 Makes fine adjustments to the tone.
MODE 1, 2 Type of circuit structure that is modeled
STAGE 4, 6, 8, 10, 12, 16 Extent of the circuit that is modeled
FOOT OFF, ON Effect on/off