User Manual

Message Meaning
Cannot recall! (Internal error) The scene cannot be recalled due to an internal error.
Cannot save now! (mixing data corrupt)
Control surface data is corrupt and cannot be saved. To
recover the data, access the DEVICE SYNC screen, and then
re-sync data in the DSP -> CS sync direction. Alternatively,
access the SAVE/LOAD screen and load the control surface
setting file. Otherwise, initialize the control surface.
Cannot Select for GLOBAL PASTE! (too many scenes; max.
100)
You cannot select more than 100 scenes for the Global Paste
operation.
Cannot store! (too many scenes; max. 1000)
The scene cannot be stored because the maximum number
(1,000) of scenes that can be stored has already been
reached.
Cannot sync in this direction! (DSP is already online)
If the control surface or PM Editor is connected with the DSP
engine online, you will be unable to sync to transfer data to
the DSP engine.
Cannot sync in this direction! (mixing data corrupt)
Data is corrupt. Syncing in this direction is not available. If
the control surface data is corrupt, syncing in the CS -> DSP
direction is not available. If the DSP engine data is corrupt,
syncing in the DSP -> CS direction is not available
Cannot trigger event! (event not found)
You cannot trigger any events from a device other than the
console, or non-existing events.
Cannot trigger event! (Event List can only be operated from
main console)
Cannot trigger event! (event list disabled) If an event list is disabled, you cannot recall events.
Cannot undo! (Internal error) The Undo operation failed due to an internal error.
Cannot update scene! The scene failed to be stored due to an internal error.
Channel pair made The channels are paired.
Channel pair made. (plug-ins and GEQ’s have been
unmounted)
The channels are paired. Inserted plug-ins and GEQ are now
unmounted.
Channel pair released The channel pair was canceled.
Channel pair released. (plug-ins and GEQ’s have been
unmounted)
The channel pair was canceled. Inserted plug-ins and GEQ
are now unmounted.
Channel set to default Channel data is reset to its default value.
Console initialization [XX] completed The console initialization is complete.
Console local I/O model type conflict!
An internal error occurred on the console. Connections
inside the operating panel may be faulty. Please contact your
Yamaha dealer.
Console local I/O not responding! Try updating console
firmware.
The system cannot communicate with the console’s built-in
Local I/O section. Refer to the Firmware Update Guide
(separate document) to use FIRMWARE UPDATER for a
recovery operation.
Console Network: ring connection open! Check cable
connection.
The system detected that the ring connection of the console
network is disconnected. Check the cable integrity and
connection.
Cooling fan error! (XXX) Contact Yamaha service
The system detected faulty cooling fans on the console.
Please contact your Yamaha dealer.
Couldn’t access the file The specified directory or file does not exist.
Couldn’t delete file The system failed to delete the file.
Couldn’t rename file The system failed to rename the file.
1004
Messages > Messages