User Manual

Message Meaning
Editor initialization [XX] completed The Editor initialization is complete.
Error occurred at Secondary Port.
When using redundant settings, the network cable of the
secondary port was disconnected.
Fader bank snapshot is done. Fader bank snapshot has been taken.
File access busy!
The system did not complete the operation because it is
currently processing internal data. Try it again later.
File already exists!
A file with the same name as the one you are about to save
already exists.
Finished loading file File loading is complete.
Finished saving file The file save operation is complete.
GPI 5V output error! Disconnect GPI and check connection.
The system detected an abnormality at the GPI +5V output
connector. Excessive current may exist due to a short-circuit
to ground. Check the cable connection.
Home bookmarked
The status of the control panel and screens are bookmarked
via the HOME key.
HY SLOTx:Primary is not working by GIGA bit.
The primary connection of HY SLOTx is active, and is not
linked via gigabit.
HY SLOTx:Secondary is not working by GIGA bit.
The secondary connection of HY SLOTx is active, and is not
linked via gigabit.
HY SLOTx:Dante switched to secondary port.
Although HY SLOTx is using a redundant connection, only the
secondary port is being used.
HY SLOTx:No Response from I/O DEVICE. There is no response from the I/O device at HY SLOTx.
Illegal DIP Switch Setting. The DIP switch settings of the R-series unit are invalid.
Illegal MAC Address! Operating with an invalid MAC address.
Image file for Console Lock screen successfully loaded.
The image file for the Console Lock screen was loaded
successfully.
Image file too large!
The system failed to load the image file for the Console Lock
screen because the size is too large (exceeds 3072 x 768
pixels).
Inappropriate scene number (#XX)
An inappropriate scene number was assigned during the
scene renumbering operation.
Internal error! (BUFFER_FULL)
An internal error occurred on the console. If this error
persists, please contact your Yamaha dealer.
Internal error! (PANELxx_COMMUNICATION_ERR)
An internal error occurred in the console. Communications
inside the operation panel may be faulty. Please contact your
Yamaha dealer.
Internal error! (PANELxx_DISCONNECTED)
An internal error occurred in the console. Connections inside
the operating panel may be faulty. Please contact your
Yamaha dealer.
Internal memory corrupt! Try initializing console and restart.
Internal memory is corrupt. Initialize the console, and then
restart it.
Internal memory corrupt! Try initializing editor and restart.
Internal memory is corrupt. Initialize the console, and then
restart it.
Interval from Previous Event is too short! The event execution interval in the event list is too short.
IP Address for StageMix is not available! Failed to set the IP address for StageMix.
Loading aborted File loading was interrupted.
1006
Messages > Messages