User Manual

Message Meaning
Low Battery! (DSP Engine)
The internal battery capacity of the DSP engine is low. The
internal clock may not keep the correct time. Please contact
your Yamaha dealer for information regarding battery
replacement.
Max. HY slot channel count exceeded! (256)
The number of output channels in the DSP engine assigned
to TWINLANe exceeds the maximum number (256) of
channels allowed. Limit the number to 256 or less.
Max. TWINLANe channel count exceeded! (400)
The number of output channels in the entire system assigned
to TWINLANe exceeds the maximum number (400) of
channels allowed. Limit the number to 400 or less.
Memory Error. The backup memory of the R-series unit is damaged.
MIDI: Data framing error! MIDI data Rx framing error occurred.
MIDI: Data overrun error! MIDI data Rx overrun error occurred.
MIDI: Rx buffer full! MIDI Rx buffer is full.
MIDI: Tx buffer full! MIDI Tx buffer is full.
Mismatch of currently installed firmware. For correct system
operation, please ensure matching firmware is installed in all
system elements.
A mismatch in firmware versions was detected. Update the
firmware, and check again.
Mixing data corrupt on Control Surface! To recover:- - Go to
DEVICE SYNC screen and re-sync data (DSP --> CS), OR - Go to
SAVE/LOAD screen and load a complete settings file, OR -
Initialize this control surface
The internal data of the control surface is corrupt. To recover
the data, access the DEVICE SYNC screen, and then re-sync
data in the DSP -> CS sync direction. Alternatively, access the
SAVE/LOAD screen and load the setting file. Otherwise,
initialize the control surface.
Mixing data corrupt on DSP Engine! To recover, go to DEVICE
SYNC screen and re-sync data (CS --> DSP).
The internal data of the DSP engine is corrupt. To recover the
data, access the DEVICE SYNC screen, and then re-sync data
in the CS -> DSP sync direction.
Mixing data corrupt on Editor! To recover:- - Go to DEVICE
SYNC screen and re-sync data (DSP--> EDITOR), OR - Go to
SAVE/LOAD screen and load a complete settings file, OR -
Initialize this editor
The internal data of Editor is corrupt. To recover the data,
access the DEVICE SYNC screen, and then re-sync data in the
DSP -> EDITOR sync direction. Alternatively, access the SAVE/
LOAD screen and load the setting file. Otherwise, initialize
the control surface
Mixing data corrupt on Editor! To recover, go to DEVICE SYNC
screen and re-sync data (EDITOR --> DSP).
The internal data of Editor is corrupt. To recover the data,
access the DEVICE SYNC screen, and then re-sync data in the
EDITOR -> DSP sync direction.
Multiple word clock masters found!
Multiple DSP engines that are assigned as the word clock
master have been detected. Assign the word clock master to
only one unit in the system.
No Battery! (Console)
The internal battery of the console is exhausted. The internal
clock cannot keep the correct time. Please contact your
Yamaha dealer for information regarding battery
replacement.
No Battery! (DSP Engine)
The DSP engine’s internal battery is exhausted. The internal
clock cannot keep the correct time. Please contact your
Yamaha dealer for information regarding battery
replacement.
No scene to update. Store scene first.
The Update function is not available because there is no
scene. Store a scene first.
Offset values can be edited only when OVERLAY is ON
You can set the Overlay offset values only when Overlay is
turned on.
1007
Messages > Messages